RAM means Random Access Memory, your computer processor RAM to store some of the data needed to make your programs work.

RAM is used millions of times every second. A computer uses Ram to hold temporary instructions and data needed to complete tasks.

This enables the computer’s Central Processing Unit (CPU), to access instructions and data stored in memory in speedy manner.

Computer memory is crucially important to computer operation. Files and programs are loaded into memory from external media like hard drives and removable disks

Memory can be built right into a system board, but it is more typically attached to the system board in the form of a chip or module. Inside these chips are microscopic digital switches, which are used to represent binary data.

There are three main types of RAM:

SDRAM
DDR
Rambus DRAM

SDRAM (Synchronous DRAM)
168-pin SDRAM DIMMs. SDRAM started out running at 66 MHz able to scale to 133 MHz (PC133) up to 180MHz or higher.

DDR (Double Data Rate SDRAM)
DDR basically doubles the rate of data transfer of standard SDRAM. DDR memory operating at 333MHz actually operates at 166MHz times 2 (PC333 / PC2700) or 133MHz times 2 (PC266 / PC2100) it has 2.5 volt technology that uses 184 pins in its DIMMs. Incompatible with SDRAM physically, but uses a similar parallel bus

Rambus DRAM (RDRAM)
RDRAM is a serial memory technology in three kinds, PC600, PC700, and PC800. PC800 RDRAM double the maximum throughput of old PC100 SDRAM, but a higher latency. RDRAM designs with multiple channels, such as those in Pentium 4 motherboards.

DIMMs vs. RIMMs

DRAM comes in two major forms: DIMMs and RIMMS.

DIMMs are 64-bit components, but if used in a motherboard with a dual-channel configuration like Nvidia nForce chipset you must pair them to get maximum performance.

DIMMs for SDRAM and DDR are different, and not physically compatible. SDRAM DIMMs have 168-pins and run at 3.3 volts, while DDR DIMMs have 184-pins and run at 2.5 volts.

RIMMs use only a 16-bit interface but run at higher speeds than DDR. To get maximum performance, Intel RDRAM chipsets require the use of RIMMs in pairs over a dual-channel 32-bit interface.

Common Computer Problems and their Answers

Wonder why you PC stops serving in all its glory? Hmm, chances are you need to do something to fix it. It’s like human that has an ailment and needs some medicine to feel well. Here are some of the common problems encountered by a common PC.

1.    The computer takes long time to start, shut down, open programs and folders

A:  You might need an upgrade of your Processor or add another System Memory (RAM)

2.    The computer crashes displaying blue screen with error messages or freezes

A: Update your OS software, reinstall Windows OS or add RAM

3.    There’s a messages that pops out saying “Running low on Disk Space”

A: add another Hard Disk or Upgrade to a higher capacity Hard Disk

Convert your CD’s into Digital Format Songs

If you want to convert tracks from your CD’s into a digital format songs, which you can be played in your computer by using the media player or a digital song player of your choice (e.g. Winamp). First, you need to “rip” the CD and encode the said format into MP3 or WMA, OGG, AAC etc.

You have to use Digital Music players

Windows Media Player – included in your windows enabled PC
WinAmp – you can download winamp here
MusicMatch Jukebox – you can download their program here

OR

You can buy from various Internet Music Stores

Another option to own a collection of Digital music is to buy from internet digital song marketplace. Some offer membership that renewable for a year or less with countless access to their song libaries by listening online or downloading the file into your computer.

Here’s some online music store

MSN Music
Napster
Yahoo Music
iTunes

Tips for Faster PC Performance
Are you annoyed with your PC’s Performance? Don’t fret Honey.. With just simple steps you can make your pc faster!!! Just do the following:

Clean out the Registry. The larger your Windows Registry, the longer the OS will take to boot. Use Registry Cleaner.
Use fewer fonts. Loading hundreds of system fonts takes time. If you have more than 500 fonts on your PC
Add RAM (SDRAM,DDRAM, DDR2, DDR3). Faster hardware means faster boots (and shutdowns, and everything in between). There’s no cheaper, more effective way to improve your hardware’s performance than by adding RAM.

Add Windows XP to Your Windows Vista Enabled PC

You need :

1. Windows XP Installer CD
2. Windows Vista DVD

Before doing anything, back up your system… Just in case.

If you’re ready…

Follow these steps:

1. In Vista, click Start, type diskmgmt.msc, and press Enter. Click Continue if prompted by User Account Control.

2. Right-click a drive and choose Shrink Volume. Specify the amount to shrink, which in this case is the amount you want for your XP partition. If you want to allot 10GB of hard disk space for your XP system, type in 10000 in the box. Click Shrink.

3. Right-click the newly available area and choose New Simple Volume. When prompted, check Perform a quick format to format the volume with NTFS.

4. When the wizard is done formatting the new volume, you can assign or rearrange drive letters as needed.

To do that, right-click a volume or the CD/DVD drive and choose Change Drive Letters and Paths. If a volume hasn’t got a drive letter yet, click Add. Otherwise, select the drive icon in the dialog box and click Change.

5. When you’re done with partitioning, exit Disk Management. Insert your XP disc into the drive and restart your system. Boot from your XP CD.

6. Install XP. When asked for the target drive, select your new partition and press Enter. When prompted choose Leave the current file system intact (no changes) and press Enter. Continue the installation process until it’s finished and XP has started.

7. Your system now boots to XP, so we’ll need to do some fixing to set up a boot menu. Insert your Vista DVD and restart the computer from it. Click Next in the first screen.

8. Don’t click Install when prompted! Instead, click Repair Your Computer in the lower-left corner.

9. When the System Recovery Options dialog appears, make sure Microsoft Windows Vista is selected and click Next. In the next dialog box, select the Command Prompt option at the bottom.

10. In the command-prompt window, type the following commands and press Enter after each one:

bootrec.exe /fixMBR bootrec.exe /fixBoot

11. Close the command prompt and click Restart.

12. When your computer has booted into Vista, click Start, type cmd.exe, and press Ctrl+Shift+Enter to make the command window open with elevated privileges. Click Continue, if prompted by User Account Control.

13. Type the following commands in the command window, one at at time, pressing Enter after each one. After each command, you should get the response, “The operation completed successfully.” A response of, “The specified entry already exists,” is OK, too. If not, retype your command to make sure you’ve entered it correctly. If Vista is installed on a drive other than c:, change the first command below to use the proper drive letter. The curly braces around {ntldr} in each command must be typed exactly as shown:

bcdedit -set {ntldr} device partition=C: bcdedit -set {ntldr} path \ntldr bcdedit -displayorder {ntldr} -addlast bcdedit -set {ntldr} description “Microsoft Windows XP”

The next time you restart your system, you should be see a prompt that will let you choose between Vista or XP. Select the one you want and press Enter.

Remove that jamesgo.dll in your hardrives/hardisk

Steps

Start your PC in safe mode.
Open regedit by typing “regedit” in the run command
Find all test.bat codes and erase them one by one until your registry is clean.
Find test.vbs codes and erase all of them.
Find jamesgo.dll and erase the string “jamesgo.dll”.
Continue searching and erasing until your registry is clean.
Repeat the process once or twice to ensure that the data has been erased.

Or

Open your Task manager using Ctrl+ alt + Delete simultaneously

Open your command prompt in shell C:
When in Command prompt,
you can see this —> C:\
type after the C:\ this “del autorun.* /f /s /q /a”
“del test.* /f /s /q /a”
“del jamesgo.* /f /s /q /a”
Remember type those command without the qoutes.
Restart you PC after delete commands.
Check your Hard Disk if jamesgo is still there.

Goodluck…comment if it helped you..

Youre expreriencing fluctuation in your DCHP Connection? No problem, just renew your IP and it may get a good result. Follow the instruction and you’ll be set in a minute.

For Windows 95, 98, or ME

Click Start, then Run. In the window that appears, type command

In the DOS window that opens, type winipcfg

A window will appear with network information:

First, click Release All. (Many of the numbers shown will change to a string of zeroes.)

Then click Renew All. (Your IP address and other networking numbers should re-appear.)

Then click OK. Your IP address has now been renewed.

For Windows 2000, NT, or XP

Click Start, then Run. In the window that appears, type cmd

In the DOS window that opens, type ipconfig

Your networking information will be printed in the same window:

First, type:

ipconfig /release

Many of the numbers shown will change to a string of zeros. Then type:

ipconfig /renew

Your IP address and other networking numbers should be displayed on the screen. Your IP address has now been renewed.

Check your IP by typing:

ipconfig /all

Your screen should look similar to this:

and done!

Some of computer users around the world still use the old fashioned mouse device that has a ball in it. Eventually, the dusts accumulate inside the mouse which prevents the ball to roll freely. In this regard, replacing it with an optical can be a wise move.

Here’s a hint on how to replace your mouse device

If your CPU utilizes the PS2 mouse port, you need a PS2 to USB Connector/Adapter

a.    If your new mouse is designed to use a USB interface, simply plug your new mouse in the USB Slot that can be located at the back of your CPU
b.    If your new mouse is not USB, shutdown your computer first.
c.    Unplug your current mouse
d.    Plug your new mouse in the PS2 or USB slot
e.    Start your PC, and its now ready to use

Note: if your OS is Windows 98 you need to install the driver for your new mouse.

SEO Techniques can be found everywhere on the Internet and draws a large crowd who wants to learn on how to place their sites into the highest rank in search engines list. However in obtaining higher page rank in search engine database you have to work hard and a lot of patience for you to draw a large number of hits everyday.

Here are some hints on Seo technique that can enhance the page ranks in search engine.

Use appropriate file names:
Always consider the file name of your posted topic be related to your domain name.

Add Meta tag on your template:
Although meta tags can’t guarantee to place your site on the higher list rank, it can help in driving topic when somebody made a query in a search engine that is related to your posted topic

Add keyword synonyms to your posted topic:
Your keyword placement and density can drive people on your site if configured correctly, always use or include synonyms of your keyword

Only post quality content:
Quality content of a website can drive visitors to come back for more

Avoid Frames:
You should not use frames on your site since this prevents bots and spider to refrain from indexing your files extensively

Create a site map:
Sitemap is just an structured enumeration of your site, which is needed by bots when crawling your site

Always update your site:
A good ranking requires monitoring; check your blog for broken links and inaccessible pages.

This is just a few hints…you can obtain more accurate SEO techniques when you browse our friendly neighborhood Mr. Google.

Our Official Logo

For any comments and suggestions send emails to admin [at] techpinay.com